Elkhart-brass Extender 8598 Bedienungsanleitung

98298000 Rev. B

8 Side View Unit Dimensions

9 Top and Bottom View Unit Dimensions

10 VI. Installation Instructions Warning: Mounting System not intended to support plumbing or absorb stress from plumbing. See Figure 3. A. Exten

11

12 B. Controller 1 Mark the panel cutout and mounting screw pattern per dimensions in Figure 7. 2 Cut a rectangular clearance opening and drill f

13 C. Wiring (See Figure 8 for connections). Caution: Route wires away from sharp objects and heat sources. Support with ties as neede

14 VII. Operating Instructions NOTE: The Extender cannot be operated with water pressure above 10 PSI. The Extender is the perfect accessory fo

15 If either button, (“UP” or “DOWN”), on the controller is pushed while the waterway is pressurized all three LED’s will blink on and off at a very

16 IX. Parts Drawings

17 ITEM P/ N DESCRIPTION QTY 1 31030000 3"-150# COMPANION FLANGE 1 2 64096000 CAP SCREW 5/16-18 X 1.5 LG ZNC 4 3 23576000 CUSHIONED LOO

Table of Contents I. Product Safety...

18 X. Hydraulic Data

Notes:

98298000 Rev. B CORPORATE OFFICES: ELKHART BRASS MANUFACTURING CO., INC. 1302 W. BEARDSLEY AVENUE ELKHART, IN 46514 TEL. (574) 295-8330 TOLL

1 I. Product Safety Important: Before installing and operating this equipment, read and study this manual thoroughly. Proper installation is esse

2 II. System Features Figure 1 8598 Features

3 Figure 2 Extender Front Panel Controller Features

4 III. System Component Descriptions A. 8598 Extender The Extender is an electric operated telescoping waterway. It is designed to elevate a deck

5 V. Mounting Structure Requirements The mounting structure must be able to safely withstand the forces shown in Figure 3. For monitor and nozzle co

6 Nozzle Reaction Formula STRAIGHT BORE NOZZLES NR = 1.5 d ² NP Where NR = Nozzle Reaction (Pounds) d=Nozzle Diameter (Inches) NP = Nozzle Pressu

7