Elkhart-brass Vulcan 8593-xx EXT Bedienungsanleitung

EELLKKHHAARRTT BBRRAASSSS MMFFGG.. CCOO..,, IINNCC.. 1302 WEST BEARDSLEY AVENUE  P.O. BOX 1127  ELKHART IN 46515  (574) 295-8330  FAX (574)

Page 10 C. RF Receiver/Control Module The RF Receiver/Control Module uses a state-of-the-art PIC (Programmable Integrated Circuit) chip design. This

Page 11 D. RF Transmitters The monitors use W.E.T. (Wireless Electronic Technology), an innovative wireless radio link, to send all commands from

Page 12 3. 81327201 Secondary Panel Mount Transmitter (Figure 10) The fixed transmitter sends signals to the monitor via an encoded radio signa

Page 13 7. 81492001 Auxiliary Battery Pack (Figure 13) A 12-volt, 12 amp-hr. sealed lead-acid battery pack is available to allow operation of the m

Page 14 IV. CONTROL SYSTEM SPECIFICATIONS Handheld Transmitter Specifications  Input power 2 AA batteries (Alkaline recommended)  Output power

Page 15 V. INSTALLATION INSTRUCTIONS A. Component Mounting 1. Monitor a) 3” NPT Base: Apply an appropriate thread sealant to the 3” NPT nipple.

Page 16 Figure 15 81327001 and 81327011 Fixed Transmitter Panel Template

Page 17 2. Monitor Wiring a) Place a 10A fuse between the red lead (Pin C)of the monitor and a switched positive power lead on the vehicle. Attach

Page 18 foot antenna cable provided to locate one of the antennas outside the vehicle compartment in a position that provides the least obstructed li

Page 19 mounting surface or bracket. Assemble nuts and lock washers to each mounting screw then tighten. d) The harness has the same wiring configur

Page 2 System Information: Monitor Serial Number: _________________________________________________ Monitor Accessories (nozzle gallonage an

Page 20 E 8500-01 Vulcan RF, 8593-01 Copperhead RF – Blink – Dash Panel Indicator Application F 8500-01 Vulcan RF, 8593-01 Copperhead RF – NonBlink –

Page 21 Caution: While reassembling the handheld remote, ensure both battery and antenna leads do not become pinched. Figure 19 Transmitter Sec

Page 22 D. Limit Setup and Stow Position Programming 1. 8500-01 EXT, 8593-01 EXT Left-right travel limits are not programmable in the 8500-

Page 23 NOTE – All six programming steps must be completed otherwise the changes will not be stored to permanent memory! (1) Hold the Red Programmin

Page 24 NOTE – All six programming steps must be completed otherwise the changes will not be stored to permanent memory! (1) Move the monitor to th

Page 25 VI. OPERATING INSTRUCTIONS A. Normal Operation The 8500 RF and 8593 RF Monitors use the standard Left/Right, Up/Down, and Fog/Stream command

Page 26 e) Press and release the oscillate button to engage the oscillation function. f) The monitor will oscillate between the limits until the o

Page 27 Warning: Never activate the “Stow” feature while water is flowing. Serious injury to personnel and damage to apparatus coul

Page 28 VII. MAINTENANCE & INSPECTION A. Monitor 1. Preventative Maintenance The complete monitor and control system should be inspected during

Page 29 Table 3 DS5 Status Indicator LED (Indication VS. Meaning) Reference Indication Meaning 1 Light comes on for 1 second when monitor stops Moto

Page 3 Table of Contents I. Product Safety ... 4 II.

Page 30 VIII. MONITOR & STREAM SHAPER 1. Interpreting Flow Data The following graphs offer the pressure losses for the monitor (and other devi

Page 31 2. Monitor and Stream Shaper Hydraulic Data Monitors Losses010203040500 200 400 600 800 1000 1200 1400Flow Rate (GPM)Pressure (PSI)Friction

Page 32 Elkhart Brass Mfg. Co., Inc. Mailing Address: P.O. Box 1127 Elkhart, IN 46515 USA Shipping Address: 1302 W. Beardsley Ave. Elkhart, IN

Page 4 I. PRODUCT SAFETY Important: Before installing and operating this equipment, read & study this manual thoroughly. Proper

Page 5 II. SYSTEM FEATURES Optional SM-1250E or SM-1250BEFog Nozzle and 282-A or 282-BStream Shaper8500-01 and 8593-01have Continuous 360Electronic

Page 6 Figure 2 81282001 Handheld Transmitter Features PUSH AND HOLD STOW AND FOG TOGETHER TO ACTIVATE Two-Button Stow Function Only Activate

Page 7 NEMA 4 Sealed No Control Wires to Run Flush Mount Hardwired to Vehicle Power System (Maximum current draw is 500 mA) Figure 4 81327201 Sec

Page 8 III. SYSTEM COMPONENT DESCRIPTIONS A. 8500-01 Vulcan RF and 8593-01 Copperhead RF Monitor (Figure 6) The 8500-01 Vulcan RF Monit

Page 9 The aerial Vulcan RF and Copperhead RF have special features to optimize performance as an aerial master stream device when used on a straight